We just shipped a new Telematics panel on the asset card — open any vehicle and you’ll see it sitting right under Work Orders.
It’s the stuff your fleet has always been quietly telling you. Now it’s actually listening.
What’s in it
At a glance, on every connected vehicle:
- VIN so you stop guessing which truck is which
- Engine RPM, Engine Load, Coolant Temp — is it working hard, or just sitting at idle burning fuel?
- Fuel Level and Odometer for when “how much gas is in #14?” hits Slack at 6:45 AM
- Engine Hours, External Power, Battery Voltage — early warning before a no-start
- Ignition state, live
- Check Engine, Fault Codes, Active Faults, and Distance with MIL so you know exactly how long that dash light has been on
Fault codes are color-coded. If something’s lit up, you’ll see it.
Tap anything to go deeper
Every metric with a little chart icon next to it is clickable. Tap it and you get the full history — 6 hours, 24 hours, 7 days, or 30 days.
So when a driver says “the truck’s been running rough all week,” you can pull up Engine RPM over 7 days and actually see the spikes. When a battery dies, you can scroll back and watch the voltage sag for three days before it gave up.
Why we built it
Most fleet platforms either bury this data three menus deep or charge you extra to see it. We wanted it on the same screen as the map — because if you’re already looking at where the asset is, you’re probably about to ask how it’s doing.
Open any asset card and the panel’s already there. Nothing to enable, nothing to configure. If your tracker supports it, the data shows up.
Try it now
Pop open any vehicle in your fleet, expand the Telematics section on the asset card, and click around. The data’s been there all along — we just stopped hiding it.
Got a metric you wish was on there? Tell us. We’re already eyeing what to add next.
